Cura generated code on CR-10; heats only bed and not nozzle; doesn't print - UltiMaker Cura - UltiMaker Community of 3D Printing Experts
Por um escritor misterioso
Descrição
Using Cura, I select my printer, CR-10 (1.1.6), the correct flavor, Merlin, verify that I have a temperature of 205 for the nozzle and 60 for the bed, and slice the file and save as gcode. When I attempt to print, the nozzle will heat correctly, but the temperature set point for the bed remains a
80 posts tagged with 3D Printing Tips
Introduction to Low-Cost 3D Printing
print quality - Under extrusion when starting outer wall - 3D Printing Stack Exchange
Creality CR-6 SE, CR-6 MAX & CR-10 Smart Community, Hi, does it matter to the community firmware that the bed flex during ABL probing
Retraction: Just say No to oozing
How do I turn off this initial triangle? - Page 3 - UltiMaker Cura - UltiMaker Community of 3D Printing Experts
On some models, the generated code causes the nozzle to crash into the print surface · Issue #7292 · Ultimaker/Cura · GitHub
Cura 4.13.1 - Newbie doing something wrong! - UltiMaker Cura - UltiMaker Community of 3D Printing Experts
On some models, the generated code causes the nozzle to crash into the print surface · Issue #7292 · Ultimaker/Cura · GitHub
The 3 Best 3D Printers for 2023
Cura not responding on Windows : r/Cura
GUIDE] Setting up the Neptune 4 Pro with Cura 5.4 : r/ElegooNeptune4
Cura generated code on CR-10; heats only bed and not nozzle; doesn't print - UltiMaker Cura - UltiMaker Community of 3D Printing Experts
With humble bundle hosting a 3D Printing bundle I thought it a good time to post explaining how easy and cheap it is to 3D print. : r/dndnext
Cura is printing support on nothing? - 3D Printing Stack Exchange
de
por adulto (o preço varia de acordo com o tamanho do grupo)
